Instructions and manual for Scher-Khan Logicar in Russian


The Sherkhan Logikar A alarm system is a security device that uses Madic Code Pro 2 coding. In turn, the previous model of the “A” family is called Scher Khan Magicar A. It uses Madic Code Pro coding. There are no manufactured code grabbers for any Class A Sherkhan, Logikar or Magikar. But the connection diagram for the Logicar car alarm is not provided anywhere; even the operating instructions are silent about this. Maybe this diagram repeats the connection option for this signaling. It is discussed further.

Operation Manual Alarm System…

Page 2

  • Image
  • Text

2

Manual

Vehicle alarm system STSTS

SCHER-KHAN LOGICAR 1

(hereinafter referred to as the system) corresponds

mandatory requirements in the GOST R certification system,

requirements for car security devices: GOST R 41.97-99 (Uniform regulations regarding official

approval of vehicle alarm systems

(STSTS) and motor vehicles in relation to their systems

alarm system (STS)) GOST R 50009-2000 (Electromagnetic compatibility of technical equipment.

Technical means of security alarm. Requirements and Methods

tests) Thank you for purchasing a two-way car security system

systems SCHER-KHAN LOGICAR 1

Our company's continuous research and development embodies

the most advanced ideas and serve to satisfy all needs

users of our systems. System SCHER-KHAN LOGICAR 1

is a complex electronic

vehicle equipment. From its functioning and correct

installation depends on the safety of your life, health and road

situation, the quality of work of nearby radio-electronic

equipment and communications. Trust the installation of the system only

specialized service stations. During operation

Periodically check that the system is functioning correctly.

attention!

When purchasing, check that the warranty card is filled out correctly.

The manufacturer and system supplier are not responsible

for any disregard of the installation manuals and

operation, as well as for errors made during installation.

If problems arise with the operation of the system,

please contact the service center immediately for

diagnostics or consultation.

The manufacturer reserves the right to make changes to the system design

in order to improve consumer properties

Reasons why the car does not open

Before performing any steps, you need to figure out why the Sherkhan alarm system does not open the car. There could be several explanations for this:

  1. The battery is low, which is why the remote control does not provide the required signal.
  2. Interference due to which the car does not open with the Sherkhan alarm key fob.
  3. Failure of the central locking system and the drive that controls the system.
  4. Failure of one of the security system modules.
  5. Failure to synchronize the key fob with the main unit.
  6. Physical damage to the remote control requiring repair.

Above are the main reasons why the Sherkhan alarm key fob does not open the car. Taking this into account, it is necessary to act when troubleshooting.

is a car alarm with the ability to control...

Page 3

  • Image
  • Text

3

Sсher-Khan logicar 1

PURPOSE Scher-Khan logicar 1

System SCHER-KHAN LOGICAR 1

is an automobile

alarm with the ability to control via radio channel via

key fob communicator with liquid crystal display. System

exchanges information between the key fob communicator and

processor unit at a distance of up to 1,000 m. IN SCHER-KHAN LOGICAR 1

there is a function to automatically start the engine upon commands

key fob or internal timer. Car alarm is designed

for use on petrol or diesel vehicles with the system

fuel injection and on-board voltage 12 V, with mechanical or

automatic transmission. Protection of the processor unit, sensor

shock, call sensor, antenna unit is made according to the IP-40 standard and

Provides for installation inside the car. Siren made according to

IP-65 standard and can be installed in the engine compartment, away from

exhaust manifold and high-voltage systems.

content

PURPOSE OF SCHER-KHAN LOGICAR 1. ……………………………………………………………….. 3

DELIVERY SET …………………………………………………………………………………… 5

Additional components SCHER-KHAN LOGICAR 1. ……………………….. 6

LIST OF FUNCTIONS ……………………………………………………………………………………… 6

Functions of the key fob communicator……………………………………………………….. 6

Functions of the processor unit……………………………………………………………… 7

TECHNICAL SPECIFICATIONS …………………………………………………………………. 8

Types of alarm signals…………………………………………………………………………………. 8

Control methods…………………………………………………………………………………8

Protection of electrical circuits………………………………………………………………. 8

Spheres of protection………………………………………………………………………………….. 9

Other parameters…………………………………………………………………………………. 9

Batteries…………………………………………………………………………………. 9

DESCRIPTION OF KEY RINGS…………………………………………………………………………………………. 10

Symbols on the display of the key fob communicator ………………………………………… 10

Correspondence of the buttons of the main and additional key fobs…………….. 11

Purpose of key fob communicator buttons …………………………………………. 12

Setting up the key fob communicator. ………………………………………………………. 13

Turning on the display backlight……………………………………………………………….. 14

Keypad lock…………………………………………………………………………………………. 14

Advantages and disadvantages

Advantages of Sherkhan Logicar 1:

  1. Wide functionality. The model has the necessary options to protect the car.
  2. Reliability. As a result of the installation, the consumer does not have to worry about the safety of the vehicle.
  3. Low price. The cost of an anti-theft agent ranges from 3,800 to 5,000 rubles on average.
  4. High build quality. All components of Sherkhan Logicar 1 are made in a durable casing, which prevents them from breaking as a result of falls or other physical impacts.

The disadvantages include the fact that, judging by consumer reviews, malfunctions may occur in the operation of the Sherkhan Logicar 1 alarm system. Usually this drawback is due to the fact that during installation the requirements that the car must meet were not met.

Operating Guide Power Saving Mode Battery…

Page 4

  • Image
  • Text

4

Manual

Battery Save Mode…………………………………………… 14

Driving a second car……………………………………………………….. 14

Indication of the presence of a feedback signal ………………………………………….. 15

SYSTEM OPERATION…………………………………………………….. 15

Arming ………………………………………………………………………………………………. 15

Arming with the engine running…………………………………… 17

Arming in Pit-Stop mode …………………………………………………………… 19

Automatic arming …………………………………………. 22

Alarm mode………………………………………………………………………………….. 23

Reminder mode……………………………………………………………………………….. 24

Disarming…………………………………………………………………………………….. 24

Automatic return to security mode………………………………………………. 26

Searching for a car………………………………………………………………………………….. 27

Opening the trunk ……………………………………………………………………………… 27

Checking the condition…………………………………………………………………………………. 28

Panic mode or JackStop™……………………………………………………………….. 29

Turning off the siren signals……………………………………………………………….. 30

Valet mode……………………………………………………………………………………………………………. 31

Turning the shock sensor on and off…………………………………………….. 33

Central locking control by turning the ignition on/off

or by tachometer signal………………………………………………………. 35

“Turbo” mode………………………………………………………………………………………… 35

Additional channel 1 control ………………………………………………… 39

Additional channel 2 control ………………………………………………… 41

Control of additional channels 3, 4, 5 ……………………………………… 42

Remote engine start………………………………………………………….. 43

Automatic engine start backup mode…………………… 45

Diagnosis of the causes of unsuccessful automatic engine start……. 48

Setting a timer to automatically start the engine …………………… 48

Limitation of the number of automatic starts………………………………………………………50

Disarming the system without a key fob and using a personal code ..... 50

Disarming the system without a key fob using PIN……………….. 51

Engine blocking ………………………………………………………………………………………. 53

Additional lighting when arming and disarming ……………. 53

Protecting the radio channel from code interception…………………………………………………………….. 53

Adjusting the sensitivity of the shock sensor……………………………………….. 53

How to attach a keychain Scher Khan Magicar A

You can program the Magikar A pager in two ways: without using a PIN code, and using a password.

You can bind an additional key fob without a PIN code using the following algorithm.

  1. Activate the ignition three times. After this, the alarm will indicate entry into programming mode with one flash.
  2. Complete the next step in four seconds. Press key 1 on the first communicator. Confirmation is a one-time activation of the lighting devices. Enter the details of the second and third remote control. Correct action will be indicated by one flash of emergency lights. As soon as you enter the third code, the turn signals will light up twice and the control unit will exit the programming mode. You can leave the settings in another way, without doing anything for 4 seconds.

Here's how to attach the remote control when using a PIN code.

  1. This step must be completed within four seconds. Activate the ignition three times. Turn off the ignition.
  2. At this step you also have 4 s. Turn on the ignition. The number of key turns is the first value of the secret code. In four seconds. The turn signals will work once - you can enter the second digit of the PIN code.
  3. In the same way, enter the second value of the personal code. The hazard lights will come on once.
  4. The next action must be completed within four seconds. Press the 1st button of the first remote control. An optical flash will follow. Enter the details of the second and third key fobs. Confirmation of correct actions is a single activation of the signal lights. After you enter the code for the third pager, the emergency light will flash twice and everything will be saved.

We have programming instructions for the Sherkhan Magikar 7 key fob.

Programming the tachometer signal………………..

Page 5

  • Image
  • Text

5

Sсher-Khan logicar 1

Programming the tachometer signal……………………………………… 54

KEY FOB PROGRAMMING ………………………………………………………. 54

PROGRAMMING FUNCTIONS USING THE KEY FOB ………………… 55

Menu of programmable functions No. 1 ………………………………………………….. 56

Detailed description of programmable functions of menu No. 1 …………………. 59

Setting all programmable functions of menu No. 1 to factory defaults

values ​​…………………………………………………………………………………………………………… 66

Menu of programmable functions No. 2 ………………………………………………….. 66

Setting all programmable functions of menu No. 2 to factory defaults

values ​​…………………………………………………………………………………………………………… 69

contents of delivery

When purchasing a system, make sure that it is included. Specified

The scope of delivery is basic and can be expanded to include

according to the buyer's wishes with additional components.

Name

quantity

Operating manual………………………………………………………………………………… 1

Installation Guide………………………………………………………………………………… 1

System installation and configuration diagram……………………………………………………1

Processing unit SCHER-KHAN LOGICAR 1 ……………………………………….. 1

Keychain communicator………………………………………………………………………………………………. 1

Additional key fob………………………………………………………………………………….. 1

18-pin power connector with cable

and five CN 1 fuses (white CN 1 connector) ……………………………. 1

12-pin low current connector with cable

(black CN 2 connector) ……………………………………………………………………………………….. 1

LED (VALET) with cable (3-pin white connector CN 3) …………………… 1

Shock sensor with cable (4-pin red connector CN 4)……………….. 1

4-pin additional sensor wiring harness

(green CN 5 connector) ………………………………………………………………………………………………. 1

Antenna module with cable (6-pin blue connector CN 6) ……………. 1

2-pin power connector for integrated motor lock with

wires (matching connector CN 7 comes out of the block on wires)………… 1

Locking relay with block……………………………………………………………….. 1

Hood/trunk limit sensor (brown wire without connector) .... 1

Description of key fobs

Page 10

  • Image
  • Text

10

Manual

attention!

Use only high-quality batteries. Usage

poor quality batteries can lead not only to

shortening the service life of the key fob, but also damaging it.

DESCRIPTION OF KEY FOCKS

PREPARING THE KEY FOB-COMMUNICATOR FOR OPERATION

Before using the key fob, remove the cover latch

battery compartment, press the cover and slide it to the side

opposite the antenna. Install the battery into the battery compartment,

observing the polarity indicated on the bottom of the battery compartment. Close and

secure the battery compartment cover. The keychain is ready for use.

symbols on the display of the key fob communicator

Indicator of operation of the key fob communicator transmitter and

presence of communication from the key fob to the processor unit Indicator of the presence of a feedback signal Low battery indicator

key fob communicator and Battery Save Mode

Time indicator, key fob battery voltage -

communicator and additional text information Valet mode indicator Security mode status indicator. Lock indicator and

unlocking locks in Valet mode Siren signal off indicator

Shock sensor disconnect indicator

Vibration call on indicator Automatic control on indicator

central locking for ignition alarm indicator

Comments

Need instructions for use
Eduard 06/16/2020 15:10 GMT

How to remove autostart Sherkhan Logicar 6i?

Masha 04/15/2021 19:19 GMT

How to remove autostart Sherkhan Logicar 6i

04/15/2021 19:25 GMT

Select → I found instructions for my car alarm here! #manualza

  • Click →

Who smoked the anti-smoking instruction?

Manualza!manualza.ru

Still not with us?

Instructions for activating the new Mobicar A key fob

You can enter three pager codes into the anti-theft system's memory. You can set up a remote control with a screen, as well as a small key fob, using the following algorithm.

  1. Activate the ignition three times. If everything is done correctly, the emergency lights will work once. You have entered programming mode.
  2. The next step must be completed in four seconds. Press key 1 of the first key fob.
  3. Programming exits automatically if you take no action for four seconds.

The control unit has three cells for storing key fob codes. When recording a fourth remote control, the first one will be deleted from memory. Find out how to turn the sound on or off on your Sherkhan keychain.

Rating
( 2 ratings, average 4.5 out of 5 )
Did you like the article? Share with friends:
For any suggestions regarding the site: [email protected]
Для любых предложений по сайту: [email protected]