How to change engine mounts on a VAZ 2110: what you need to know

Well, let's drive the car into the pit. I’m going to look at the rest of the joints, leaks, etc. at the same time.

Cracked coolant hose

Leaking crankcase gasket in the flywheel area

The drive rubs against the plastic protection

But this is all nonsense. What about the checkpoint? Why don't the transmissions stick in?

And the gears don’t stick in because the fastening of the gearbox and the jet thrust have been torn off. Accordingly, the gear shift lever moves, but not along the desired trajectories.

Torn transmission support

Torn off ball joint of gearbox thrust

Having unscrewed the gearbox support, I saw an even bigger problem - a torn spar under the support itself.

Naturally, you can’t do without welding here. We clean the body from anticorrosive to metal. Let's cook. We cover the weld seam and the area around it with a new anticorrosive agent.

Then we attach a new gearbox support.

Now remove the ball joint for the gearshift lever. The manual says that this needs to be done from the cabin and that you need to disassemble the massive amount of trim in the cabin. I don't think so. Everything is made from a pit, but to be honest, with some Kama Sutra...

Unscrew the old one. Using a small screwdriver, pry up the retaining ring and remove it.

Clean the ball with a rag

We put grease into the new one. We stand and lock it with a ring. This is the Kama Sutra, of course...

The new one costs as it should

And now we adjust and tighten the main gearbox support.

Actually, now the gears are stuck in normally

Rating
( 2 ratings, average 5 out of 5 )
Did you like the article? Share with friends:
For any suggestions regarding the site: [email protected]
Для любых предложений по сайту: [email protected]