Fuses and relays Ford Mondeo (Mk4; 2010-2014)

Fuse box in the passenger compartment

This is the main area with protective inserts. The block underwent reformatting in 2009, when the car was restyled and facelifted. The fuses installed in this section are connected to electrical circuits responsible for driving comfort, the operation of interior components, lighting, and the braking system.

You can find the unit on the dashboard, to the right of the steering wheel, under the glove box. It takes up space on the top cover of the multifunctional electronic unit and to access it you need to turn a quarter turn of the OIE base lock.

PSU repair

As mentioned earlier, repairing the fuse box in a Ford Mondeo is not that difficult. To carry out all the procedures, you only need to know some of the nuances of the procedure and have basic car repair skills. If you already have the latter, then after reading the material presented below, replacing fuses or other parts will not be a problem for you.

First, it is important to know where the fuse boxes are located in the Ford Mondeo. Regardless of the model generation, they have a standard location and are represented by two different units:

• The first power supply is mounted in the engine compartment. As a rule, it is located near the battery. Finding the unit is easy, just open the hood and find the black box, by opening the lid of which you can gain access to the control panel and relay.

• The second power supply is located on the left in the cabin under the dashboard. To gain access to it, you will have to dismantle part of the dashboard, and then remove the plastic cover from the unit.

Once you have found the required block, you can begin repairs. During all procedures, it is important to adhere to simple recommendations. The main list of these is as follows:

• Before replacing, be sure to de-energize the vehicle's electrical system (turn off the engine, turn off the ignition and disconnect the battery terminals).
• Dismantle all elements of the car very carefully. All parts of the power supply unit and the interior are quite fragile, so it is very easy to damage them with careless movement.
• When replacing any power supply element, do it with exactly the same part. When replacing a fuse or relay, it is important to ensure its correct location, current rating and marking. Otherwise, there is a risk of causing more serious problems with your repairs.
• Never replace PCBs or relays with wires or homemade insulators - this is very dangerous.
• Having completed the repair, reassemble the vehicle in the reverse order and only then operate it.

Block under the hood

Its content in pre-restayle and after it does not differ as much as in the case of the salon area. In general terms, it remains the same as it was released in 2007. The main changes are associated with the advent of new engines, since most of the fuses installed here are responsible specifically for the electrical circuits associated with them.

You can find this mounting block to the left of the battery; its cover is clearly visible. To remove it, you will have to press the latches on the sides. On its inside there should be tweezers-fixer for removing fusible elements.

Additional relays (outside fuse box)

Mondeo 4 fuse box diagram

During its presence on the market from 2007 to 2014, the car managed to undergo a facelift in 2010, and with it came the restyling of the mounting blocks. Many protective elements were installed on the model during the modernization of the previous generation in 2004. The final set of fuses was formed with the latest update of the engine range, in 2011-2012, and is presented in the diagrams below. Below is their transcript in the form of tables.

Mounting block in the engine compartment.

Relay:

• R1 - starter
• R2 - ECR
• R3 - air conditioner
• R9 - sound signal
• R10 - headlight washer and cleaner.

Main salon block.

After restyling.

Before restyling

Rear mounting block.

Sedan and hatchback.

Station wagon.

Cigarette lighter fuse

In the modern modification of the Mondeo 4, it is numbered F7 in the central mounting block and has a power of 20 Amperes. Before restyling, it was occupied by F19 and was designed for 15 A.

Where is the fuel pump fuse and relay located?

The fuel pump insert is located in the cabin block under number F13 (and before restyling it was on F22) and is designed for 20 A.

Air conditioner relay and fuse

In the example of motor 1 6, 20 and others, the protective element is located in a block under the hood, indicated in the diagrams as F13 with a power of 15 A. In other modifications of the model, the car owner may have to find this fuse on his own. Relay number 3 is responsible for it.

Cooling fan relay and fuse

The location of the inserts for turning on the engine airflow in the Mondeo 4 depends on the model of the installed engine. If a 2.3L Duratec-HE or 2.2L Duratorq-TDCi is supplied, then you need to look for F3 (power - 70 Amperes), and if diesel engines produced in 2008 are 1 6L, 2.0L Duratorq-TDCi, 2.0L Stage V, 2.2 L, 1.6L Ti-VCT, 2.3L and 2.0 EcoBoost SCTi - then on F5 (power 60 and 70 Amperes). All elements are located in the engine compartment block.

Trunk fuse: where is it located?

The 10 Ampere F11, located in the cabin before restyling, is responsible for protecting the opening of the lock. After a separate fuse element for the circuit responsible for opening the lid and lighting the trunk, there is no provision.

Starter

The fuse for the retractor relay is located in the engine compartment under the number F15 and is rated at 40 Amperes. But the starter relay has number 1.

Radio tape recorder

In older modifications, the element can be found in the central block - this is F6 at 15 A. In newer cars, it is indicated on the diagrams as FC10 and is moved to the rear block. Rated for 10 Amps.

Generator Regulator Relay

Located at the last, this applies to all releases from 2007 to 2015. This is one of the most expensive relays, its price on average is 3 thousand rubles.

Sound signal

The fuse is located under number F31 in the motor block and has a power of 15 A.

Brake lights

It is worth looking in the central block under the designation F28, and after that - F22. The power in both cases is 5 Amperes.

High beam

Available in pre-restyling modifications of the car: there it takes the place of F9 in the cabin unit and is designed for 15 A.

Low beam

The fusible elements that protect the headlights are located in the engine compartment. In the first case their number is F43, and in the second - F40. Power - 5 Amperes.

Parktronics

In old and newer versions it is located in the rear block. It can be found on the diagrams as FB1, and in the second as FB8. The power is the same and equal to 5 A.

Reverse

The pre-restyling cabin unit is numbered F11 and is designed for 7.5 A.

Dimensions

Powered by F43 and F40.

Climate control

Before the changes, the protection element was designated as F27 in the interior, and after - F24. Its power is 5 A.

Number plate illumination

This fuse is not included as standard.

headlight washer

Located in the engine compartment under the number F24 for 30 Amps.

Fog light fuse

On the old version it was located in the cabin - this is F13 and had a power of 15 Amps.

Window lifters

Four protective inserts are installed in the rear installer. Their numbers are FA1, FA2, FA3, FA4. Responsible for the front (left and right) and rear doors. The power of each is 25 Amperes.

Heated seats

Four fuses protecting the heating system - two front and rear. They are located in the last block, each with a power of 15 A. In the diagram, the elements are designated as FB3, FB4, FB5 and FB7.

Turning relays: where are they located?

Absent.

Wiper relay

It is located in the installer of the engine compartment of the Mondeo 4 and is numbered 10.

Stove

The fuse numbered F32 is in the motor block and is rated at 5 A.

ABS

The melting element is installed inside the machine under the number F19 at 7.5 Amperes.

Ford Mondeo IV fuses

Engine control unit Dorestyling: Engine control unit 1. Replace the blown Ford Mondeo 4 fuses in the same way as was done for the central mounting block and the block located in the engine compartment, see Install the parts in the reverse order of removal.

Location of fuses, fuses and relays and their replacement Ford Mondeo 4 ford-mondeo One block is located under the hood, near the battery and air filter housing. Inside the block cover there is a fuse diagram on it. The lid is fixed with plastic clips, which just need to be pressed to the side.

Location of fuses, fuses and relays and their replacement Ford Mondeo 4 (2007-2014)

Position of relays and pres under the hood. Table what the fuses in the engine compartment are for. The second block is located under the dashboard on the right, under the glove compartment.

The block is connected to the electronic unit. You need to turn the lock clockwise and lower it. Then you can get to the fuses themselves. Placement of fuses in the interior block.

Table for the assignment of fuses in the cabin block. Using the formula, the current strength that can be used in the network is calculated to avoid misunderstandings. In other words, current equals voltage divided by resistance.

Recommendations If you are repairing the car yourself and do not go to a service station, it will be easier to print out the fuse location diagrams and store them in the car.

These parts quickly fail, and they will not have to be replaced 1. In this case, the Ford Mondeo 4 fuses are that the parts are not expensive, and replacing them is not difficult.

Fuse box: causes of failure

There are many reasons for the failure of protective inserts, but among them are those that drivers encounter in the vast majority of cases:

• wire burnout;
• breakdown of the electrical device for which one or another fuse is responsible;
• battery failure;
• wear of electrical circuit elements, from wiring to relays;
• improper repair of electrical circuit elements;
• replacing fuses with elements with a higher rating.

Car owners are recommended to inspect electrical circuits, relays and fuses at least a couple of times a year.

Light bulbs

Replacing the cigarette lighter fuse

To change it, you need to find out its location and prepare a screwdriver, tweezers and a replacement element. The new insert should be no more powerful than 20 Amps. This fuse is located in the passenger compartment.

The replacement procedure looks like this:

1. Find the multifunction electronic unit base cover lock and turn it a quarter to the right.
2. Remove the base from the holders and lower it down.
3. Remove the cover and disconnect the battery cables.
4. Find the required fusible element according to the diagram and check it with a multimeter.
5. Take tweezers or a clamp included in the unit kit.
6. Use tweezers or a clamp to pry the fuse and pull it.
7. Insert the new one in reverse order and close the block.

The power of the new element should not exceed the power of the broken one.

PSU repair

As mentioned earlier, repairing the fuse box in a Ford Mondeo is not that difficult. To carry out all the procedures, you only need to know some of the nuances of the procedure and have basic car repair skills. If you already have the latter, then after reading the material presented below, replacing fuses or other parts will not be a problem for you.

First, it is important to know where the fuse boxes are located in the Ford Mondeo. Regardless of the model generation, they have a standard location and are represented by two different units:

• The first power supply is mounted in the engine compartment. As a rule, it is located near the battery. Finding the unit is easy, just open the hood and find the black box, by opening the lid of which you can gain access to the control panel and relay.

• The second power supply is located on the left in the cabin under the dashboard. To gain access to it, you will have to dismantle part of the dashboard, and then remove the plastic cover from the unit.

Once you have found the required block, you can begin repairs. During all procedures, it is important to adhere to simple recommendations. The main list of these is as follows:

• Before replacing, be sure to de-energize the vehicle's electrical system (turn off the engine, turn off the ignition and disconnect the battery terminals).
• Dismantle all elements of the car very carefully. All parts of the power supply unit and the interior are quite fragile, so it is very easy to damage them with careless movement.
• When replacing any power supply element, do it with exactly the same part. When replacing a fuse or relay, it is important to ensure its correct location, current rating and marking. Otherwise, there is a risk of causing more serious problems with your repairs.
• Never replace PCBs or relays with wires or homemade insulators - this is very dangerous.
• Having completed the repair, reassemble the vehicle in the reverse order and only then operate it.

Important! You can determine which PCB or relay you need to change, what its rating, markings and similar nuances are, if you refer to a special power supply circuit designed specifically for your model. As a rule, it is available in the data sheet of any Ford Mondeo model and on the cover of the block itself.