How will we install
Self-installation is within the capabilities of most car enthusiasts; there is nothing difficult about it. The whole action consists of three points, which are described in detail in the electric drive guide.
- Collect all equipment and materials;
- Actually, installing the drive on the door;
- Installation and fastening of the button (if control will be from the passenger compartment).
The installation of the drive itself is quite simple; you will have to tinker with electrics and wires, and it is better to invite a person who only knows about wires. It is clear that we have begun to de-energize the system, that is, remove the terminals from the battery. We connect the electric drive according to the diagram on the guide. If something is not clear, you can get information online or from a familiar electrician.
It is better to do the installation at a car service center
Installation still involves making a couple of small holes on the door to establish a connection with the standard trunk lock. Make sure that the lock closes smoothly and freely. And don’t save time and effort on careful wiring. If we stretch it and it will do, then in the future we may get short circuits and other problems. It should be pulled along standard lines and places. It is better to solder and insulate the joints.
After installation and connection, we restore the power supply to the network and check the operation of the drive
And we pay attention to the power springs so that it doesn’t turn out that the trunk lid is too heavy and the drive doesn’t have enough traction
Comentários • 38
Excellent video But I still had the problem with the button. I pulled it out as you showed in the video, shook it, knocked it and it worked))
Hello. The problem has not been resolved. I don't have those red things. The wires are dry, without signs of rotting
The only good advice on the entire Internet! I struggled for a long time looking for the cause, but I found this video and immediately easily fixed the problem
